Use this page to configure general behavior of CLion.
Reopen last project on startup
Select this checkbox to have CLion re-open the last opened project on startup.
Confirm application exit
Select this checkbox to have a warning message displayed when you attempt to close CLion.
Open project in a new window
Select this option to always open a new project in a new window.
Open project in the same window
Select this option to always close the current project, and reuse the same window.
Confirm window to open project in
Select this option to have CLion ask you whether you want to open a new project in the same window, or in a new one.
Synchronize files on frame or editor tab activation
If this checkbox is selected, all the files that were changed externally are reloaded from disk when you switch to CLion from a different application, or when you switch to their editor tab.
Save files on frame deactivation
If this checkbox is selected, all modified files are auto saved when you switch from CLion to a different application.
Note that you cannot disable auto-save completely by turning off this and the following option. See also, the Saving and Reverting Changes section.
Save files automatically if application is idle for N seconds
If this checkbox is selected, all modified files are auto saved at regular time internals.
See also, the Saving and Reverting Changes section.
Use "safe write" (save changes to a temporary file first)
If this checkbox is selected, a changed file is first saved in a temporary file. If the save operation succeeds, the file being saved is replaced with the saved file. (Technically, the original file is deleted and the temporary file is renamed.)
Also, the ownership of such file changes.
If this checkbox is not selected, the ownership of a file does not change, but all the advantages of safe write will be lost.
On Closing Tool Windows with Running Process
If this option is selected, the running process disconnects and terminates silently.
Disconnect (if available)
If this option is selected, the running process is disconnected.
If this option is selected, the dialog shows up, prompting to confirm the termination.