On the Jabber Settings page, you configure the connection between Hub and a Jabber service. This lets you use Hub to verify the Jabber credentials in connected services that use Jabber for notifications.
The Hub service itself does not send any notifications over Jabber.
To enable Jabber notifications:
Click the Configure Jabber server button
- Enter values for the following settings:
Enter the server address of your Jabber service.
Enter the connection port for the Jabber server.
Enter the service name of your Jabber service provider.
Enter the Jabber ID (JID) of the account that is used to access the Jabber server.
Enable the option to use SASL authentication if required by the Jabber service provider.
Click the Change password button to specify the password for account that is used to access the Jabber server.
When finished, save your changes and click the Enable notifications button.
- Test the connection.
Click the Send Test Message button.
Enter an Jabber account to which the test message should be sent.
Click the Send button.