Saving and Reverting Changes
When working with AppCode, you don't need to worry about saving changed files: all changes are auto saved.
Unwanted changes can be undone at any stage of your development workflow. Any file or directory can be reverted to any of the previous states.
When does AppCode auto save changed files?
Autosave is initiated by:
Starting a run/debug configuration
Performing a version control operation such as pull, commit, push, etc.
Closing a file in the editor
Closing a project
Quitting the IDE
In fact, there is a lot more autosave triggers, and only the most important ones are mentioned above.
Tuning the autosave behavior
The following options are available for tuning the autosave behavior (/ ( ):
Save files on frame deactivation (i.e. on switching from AppCode to a different application).
Save files automatically if application is idle for N seconds.
Note that those are optional autosave triggers, and you cannot turn off autosave completely.
Using the Save All command
If necessary, you can initiate saving all changed files yourself. There is the Save All command for that:
Marking files with unsaved changes in the editor
Changed but yet unsaved files can be marked. For this purpose, there is the Mark modified tabs with asterisk option ( / ).
When this option is on, the files with unsaved changes have an asterisk on their editor tabs.
Saving a file under a different name
There is nocommand in AppCode. To save a file under a different name or in a different directory, use or N/A.